Lacp Ungroup Member-Independent - Dell S6100 Configuration Manual

To remove the boot up timer value, use the no delay-restore abort-threshold command.
Parameters
interval
Defaults 60 seconds
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Usage Information To abort the VLT delay restore timer value as the maximum threshold, during reload, apply the maximum time
interval to the hold-down ICL peer-up in the start-up configurations.

lacp ungroup member-independent

Prevent possible loop during the VLT peer switch bootup or on a device that accesses the VLT domain.
Syntax lacp ungroup member-independent {vlt | port-channel}
Parameters
vlt
port-channel
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Enter the interval value (in seconds) for the delay restore timer to abort. The range is
from 1 to 1800 seconds. The default is 60 seconds.
This delay restore timer applies only during reload/boot-up and not in other scenarios (for
example, during ICL flap).
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000–ON and Z9500.
Force all VLT LACP members to become switchports.
Force all LACP port-channel members to become switchports.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Virtual Link Trunking (VLT) 1673