Configuring Rip - ZyXEL Communications OLT2406 User Manual

41.2 Configuring RIP

Click IP Application > RIP in the navigation panel to display the screen as shown. You cannot manually
configure a new entry. Each entry in the table is automatically created when you configure a new IP
domain in the IP Setup screen (refer to
Figure 202 IP Application > RIP
The following table describes the labels in this screen.
Table 151 IP Application > RIP
LABEL
Active
Distance
Index
Network
Direction
Version
Apply
Cancel
DESCRIPTION
Select this check box to enable RIP on the OLT.
Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by RIP.
The lower the administrative distance value is, the more preferable the routing protocol is. See
Section 41.1.1 on page 330
Note: You cannot set two routing protocols to have the same administrative distance.
This field displays the index number of an IP interface.
This field displays the IP interface configured on the OLT.
Refer to the section on IP Setup for more information on configuring IP domains.
Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming, Both and
None.
Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-2B and RIP-2M.
Click Apply to save your changes to the OLT's run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
OLT2406 User's Guide
Chapter 41 RIP
Section 8.6 on page 102).
for more information about administrative distance.
331