Table of Contents
Advertisement
Table 54 Advanced Application > Port Authentication > 802.1x > Guest VLAN (continued)
LABEL
Host-mode
Multi-Secure Num
Apply
Cancel
19.2.3 Activate MAC Authentication
Use this screen to activate MAC authentication. In the Port Authentication screen click MAC
Authentication to display the configuration screen as shown.
Chapter 19 Port Authentication
DESCRIPTION
Specify how the OLT authenticates users when more than one user connect to the port (using a
hub).
Select Multi-Host to authenticate only the first user that connects to this port. If the first user
enters the correct credential, any other users are allowed to access the port without
authentication. If the first user fails to enter the correct credential, they are all put in the guest
VLAN. Once the first user who did authentication logs out or disconnects from the port, rest of
the users are blocked until a user does the authentication process again.
Select Multi-Secure to authenticate each user that connects to this port.
If you set Host-mode to Multi-Secure, specify the maximum number of users (between 1 and
24) that the OLT will authenticate on this port.
Click Apply to save your changes to the OLT's run-time memory. The OLT loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
OLT2406 User's Guide
168
Advertisement
Table of Contents
Troubleshooting
