Ftp Command Line Procedure - ZyXEL Communications OLT2406 User Manual

43.9.2.1 Example FTP Commands
ftp> put firmware.bin ras
This is a sample FTP session showing the transfer of the computer file "firmware.bin" to the OLT.
ftp> get config config.cfg
This is a sample FTP session saving the current configuration to a file called "config.cfg" on your
computer.
If your (T)FTP client does not allow you to have a destination filename different than the source, you will
need to rename them as the OLT only recognizes "config" and "ras". Be sure you keep unaltered copies
of both files for later use.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.

43.9.3 FTP Command Line Procedure

Launch the FTP client on your computer.
1
Enter open, followed by a space and the IP address of your OLT.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter bin to set transfer mode to binary.
5
Use put to transfer files from the computer to the OLT, for example, put firmware.bin ras transfers
6
the firmware on your computer (firmware.bin) to the OLT and renames it to "ras". Similarly, put
config.cfg config transfers the configuration file on your computer (config.cfg) to the OLT and
renames it to "config". Likewise get config config.cfg transfers the configuration file on the OLT to
your computer and renames it to "config.cfg". See
filename conventions.
Enter quit to exit the ftp prompt.
7
Chapter 43 Maintenance
Table 165 on page 351
OLT2406 User's Guide
352
for more information on