Viewing And Editing Classifier Configuration Summary - ZyXEL Communications OLT2406 User Manual

Table 57 Advanced Application > Classifier (continued)
LABEL
Socket
Number
Add
Cancel
Clear

21.2.1 Viewing and Editing Classifier Configuration Summary

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the
Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over lower layer
rule.
Figure 111 Advanced Application > Classifier > Classifier Configuration: Summary Table
The following table describes the labels in this screen.
Table 58 Advanced Application > Classifier > Classifier Configuration: Summary Table
LABEL
Index
Active
Name
Rule
Delete
Cancel
The following table shows some other common Ethernet types and the corresponding protocol number.
Table 59 Common Ethernet Types and Protocol Numbers
ETHERNET TYPE
IP ETHII
X.75 Internet
NBS Internet
ECMA Internet
Chaosnet
Chapter 21 Classifier
DESCRIPTION
Note: You must select either UDP or TCP in the IP Protocol field before you configure the
socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and
enter a TCP/UDP protocol port number. Refer to
Click Add to insert the entry in the summary table below and save your changes to the OLT's run-time
memory. The OLT loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when it is deactivated.
This field displays the descriptive name for this rule. This is for identification purpose only.
This field displays a summary of the classifier rule's settings.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
PROTOCOL NUMBER
0800
0801
0802
0803
0804
OLT2406 User's Guide
Table 61 on page 178
177
for more information.