Table of Contents
Advertisement
Table 131 Advanced Application > ONT Template
LABEL
DESCRIPTION
Storm
Enter a value in the range of 1 to 65535 and set the maximum rate in packets per second (pps)
Threshold
that packets are allowed to arrive at the remote ONT.
Plan Version
Enter the ONT planned version of up to 14 characters to upgrade the ONT's firmware via OMCI.
The planned version is the firmware ID of the firmware that you want the ONT to use.
Option 82
See
Table 104 on page 259
DHCP/PPPoE passthrough.
Circuit ID
Enter a string of up to 63 ASCII characters that the OLT adds into the Circuit ID sub-option. Spaces
are allowed.
Remote ID
Enter a string of up to 63 ASCII characters that the OLT adds into the Remote ID sub-option.
Spaces are allowed.
Disable
Deselect DHCP to add DHCP options in outgoing packets. You can set up DHCP options in the
Circuit ID and Remote ID fields.
Deselect PPPoE to add PPPoE options in outgoing packets. You can set up DHCP options in the
Circuit ID and Remote ID fields.
Pass Through
Select DHCP to forward packets with DHCP options from an ONT. Otherwise, they'll be dropped.
Select PPPoE to forward packets with PPPoE options from an ONT. Otherwise, they'll be dropped.
UNI Port
CardID 1
Select this to have the Ethernet ports on an ONT, to use 10 Mbps, 100 Mbps, or 1000 Mbps.
10_100_1000B
ASET
CardID 2 VEIP
Select this to use a virtual Ethernet card on a router mode ONT.
CardID 3 POTS
Select this to use a virtual VoIP card on an ONT.
CardID 4
Select this to use a virtual video card on an ONT.
VIDEO
CardID 5
Select this to have the Ethernet ports on an ONT to use 10 Mbps or 100 Mbps.
10_100BASET
CardID 6
Select this to have the Ethernet ports on an ONT to use 10 Mbps, 100 Mbps, or 1000 Mbps, and use
10_100_1000B
a virtual Ethernet card on a router mode ONT.
ASET_VEIP
Uniport List
Enter the numbers of the ports on the ONT.
Speed
Select the auto detection configuration attribute in the physical path termination point. Use auto
or a specific rate and duplex mode.
PMenable
Select DISABLE to disable pm (performance monitoring) on the virtual card type.
Select 64-bit to enable PM (performance monitoring) to get 64-bit counters on this virtual card
type by getting IP host performance monitoring history data ME as defined in G.988.
Select 32-bit to enable PM (performance monitoring) to get 32-bit counters on this virtual card
type by getting IP host performance monitoring history data ME as defined in G.984.4.
AID
This is the ONT's ID in the format: ont-<pon>-<ont>.
Active
This shows whether the ONT is enabled or disabled.
Description
This displays the description to aid in identifying the template.
AlarmProfile
This displays the alarm profile this template uses.
FullBridge
This displays Y if you have the ONT allow the traffic of all the four UNI ports once any one of them
is configured.
AntiMACSpoof
This displays Y if you have anti-MAC spoofing activated for the ONT.
Chapter 38 ONT Template
and
Table 160 on page 343
OLT2406 User's Guide
304
for more information about DHCP/PPPoE options and
Advertisement
Table of Contents
Troubleshooting
