Erps Commands - ZyXEL Communications OLT2406 User Manual

99.2 ERPS Commands

This table lists the commands for this feature.
Table 368 ERPS Commands
COMMAND
show erps-ring
show erps-ring <1|2|3>
erps
no erps
erps-ring <1|2|3>
ringId <ringid>
port0 <aid>
port1 <aid>
rplneighbor <port0|port1>
rplowner <port0|port1>
revertivemode <enable|disable>
wtr <1-12>
tunnelport <port0|port1>
no port0
no port1
no rplneighbor
no rplowner
no tunnelport
no ccm <port0|port1>
Chapter 99 ERPS
DESCRIPTION
Displays the status of all ERPS rings.
Displays ERPS ring status for the specified ring.
Enables the ERPS feature.
Disables the ERPS feature.
Enters the ERPS configuration sub commands to
configure the specified ERPS ring.
<1|2|3>: ring 1|ring 2|ring3
Sets the ring ID for ERPS packets. One ERPS ring
can include up to 16 nodes.
ringid: 0-15, default 0
Specifies an uplink port as port 0.
aid: msc-<slot>-<port> | <T1> | <T2>
Specifies an uplink port as port 1.
aid: msc-<slot>-<port> | <T1> | <T2>
Sets port 0 or port 1 as the RPL neighbor node.
Sets port 0 or port 1 as the RPL owner.
Use "enable" to activate the revertive switching
mode. In revertive mode, after the conditions
causing a switching are cleared, the RPL will be
blocked again.
Use "disable" to deactivate the revertive
switching mode, In non-revertive mode, after
the conditions causing a switching are cleared,
the traffic channel continues to use the RPL.
Sets the WTR (wait to restore) timer interval. WTR
timer is the time interval that the traffic channel
has to wait before re-blocking the RPL. After the
conditions causing a switch have cleared, the
traffic channel is prepared to restore to the
working transport entity. If a defect is cleared,
the traffic channel reverts after the WTR time
expires.
1-12 minutes, default 5 minutes
Sets port 0 or port 1 as the BPDU tunnel port.
Deletes port 0, CCM port 0 and R-APS protocol
port 0 configuration.
Deletes port 1, CCM port 1 and R-APS protocol
port 1 configuration.
Removes the RPL neighbor port setting.
Removes the RPL owner port setting.
Removes the BPDU tunnel port setting.
Removes the ERPS CCM configuration.
OLT2406 User's Guide
695
M P
E 3
E 3
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13