Ont Bandwidth Group - ZyXEL Communications OLT2406 User Manual

Table 131 Advanced Application > ONT Template
LABEL
Loop Guard
Storm
Threshold
PlanVersion
Ontcard ID
Ontcard Type
Uniport
Speed
PMenable
Apply
Cancel

38.2.1 ONT Bandwidth Group

Use this screen to configure bandwidth group settings for ONTs. Click ONT Bwgroup in the Advanced
Application > ONT Template screen to display the screen as shown.
Figure 185 Advanced Application > ONT Template > ONT Bwgroup
The following table describes the labels in this screen.
Table 132 Advanced Application > ONT Template > ONT Bwgroup
LABEL
ID
Chapter 38 ONT Template
DESCRIPTION
This field displays if the loop guard feature is enabled on the ONT or not.
This field displays the maximum rate in packets per second (pps) that packets are allowed to
arrive at the remote ONT.
This displays the ONT's plan version.
These are the virtual card ID numbers (1-16 possible) of the ONT.
This displays the ONT virtual card type.
10_100BASET: for Ethernet ports on an ONT to use 10 Mbps or 100 Mbps.
VEIP: for a virtual Ethernet card on a router mode ONT.
POTS: for a virtual VoIP card on an ONT.
VDSL2: for VDSL ports on an MDU.
10_100_1000BASET: for Ethernet ports on an ONT to use 10 Mbps, 100 Mbps, or 1000 Mbps.
VIDEO: for a virtual video card on an ONT.
This displays the numbers of the ports on the ONT.
This displays the speed of the physical path termination point.
This displays whether PM (performance monitoring) is enabled or not on the virtual card type.
Click Apply to save the changes.
Click Cancel to begin configuring the screen again.
DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the first
drop-down list.
Choose the template that you want the settings configured here to apply to from the second
drop-down list.
Enter the bandwidth group ID number.
OLT2406 User's Guide
305