Uni Port Vlan Settings - ZyXEL Communications OLT2406 User Manual

96.4.3 UNI Port VLAN Settings

Use the vlan command to configure VLAN flow settings for the subscriber port on the remote ONT. See
Figure 268 on page 533
configuration defined in ITU-T G.984.1.
Table 356 UNI Port VLAN Command Parameters
LABEL
remote uniport <aid>
vlan <UNIVID|SVID:CVID> [
network <VID|SVID:CVID> ] [
txtag <tag|untag|priotag>] [
pbitprof <prof> ]
<gem-port> ] [ingprof <name>]
[aesencrypt <enable|disable>]
[TR156 <enable|disable>]
[sharepri <0-7 | off>] [macnum
<1-6>] [active <on|off>]
Chapter 96 Remote ONT
for where the VLAN IDs in the UNI port VLAN command fit in the reference
DESCRIPTION
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
Configures UNI port VLAN flow settings.
UNIVID|SVID:CVID: UNI VLAN ID (1~4094) of
traffic on the UNI port to which to apply this
[ gemport
command's VLAN, QoS ingress profile, and AES
encryption settings.
network: The Network Node Interface (NNI) VID
to which the ONT translates the UNI VLAN ID
before sending traffic to the OLT. Use a number
different from the UNI VLAN to apply VLAN
translation.
txtag: Sets whether the ONT sends downstream
traffic with a VLAN tag or untagged.
gem-port
VLAN (range is 256 ~ ). A GEM port ID represents
a specific traffic flow or group of flows between
the OLT and one or more ONUs. The GEM port ID
is unique per GPON interface (see TR-156 for
more information).
ingprof
VLAN's traffic (IEEE 802.1p priority bit to TC
mapping profile).
OLT2406 User's Guide
678
: The GEM port to assign to the ONT
: The QoS ingress profile to apply to the
M P
C 13
C 13