Loopguard Command Examples - ZyXEL Communications OLT2406 User Manual

80.3 Loopguard Command Examples

This example enables loopguard on ports ge-5-1 ~ ge-5-4.
OLT2406# configure
OLT2406(config)# loopguard
OLT2406(config)# interface port-channel ge-5-1&&-4
OLT2406(config-interface)# loopguard
OLT2406(config-interface)# exit
OLT2406(config)# exit
OLT2406# show loopguard
LoopGuard Status: Enable
Port Port
No Status
---- --------
ge-5-1
1 1970
ge-5-2
1 1970
ge-5-3
1 1970
ge-5-4
1 1970
--------------------------------- SNIP ---------------------------------
The following table describes the labels in this display.
Table 302 show loopguard
LABEL
LoopGuard Status
Port No
Port Status
LoopGuard Status
Total TxPkts
Total RxPkts
Bad Pkts
Shutdown Time
Chapter 80 Loop Guard
LoopGuard Total
Status TxPkts
--------- --------
Active Enable
Active Enable
Active Enable
Active Disable
DESCRIPTION
This field displays whether or not loopguard is enabled on the OLT.
This field displays the port number.
This field displays whether or not the port is active.
This field displays whether or not loopguard is enabled on the port.
This field displays the number of packets that have been sent on this port since
loopguard was enabled on the port.
This field displays the number of packets that have been received on this port since
loopguard was enabled on the port.
This field displays the number of invalid probe packets that were received on this port.
This field displays the last time the port was shut down because a loop state was
detected.
OLT2406 User's Guide
Total Bad
RxPkts Pkts
-------- ----
0 0
0 0
0 0
0 0
587
Shutdown
Time
------------------
0 00:00:00 UTC Jan
0 00:00:00 UTC Jan
0 00:00:00 UTC Jan
0 00:00:00 UTC Jan