Qos Commands - ZyXEL Communications OLT2406 User Manual

71.2 QoS Commands

Use these commands to configure QoS settings.
Table 256 QoS Commands
COMMAND
qos bwprof <bwprofName> ustype <0 ~
5>
[sir<value>][air<value>][pir<value
>]
qos bwprof help
qos cacprof <cacprofName> [mcast-
bw <kbps>]
qos cacprof help
qos ds-meter macro-mode <pir | cir>
qos ingprof <ingprofName>
[DOT1P0TC<value>],...]
Chapter 71 Classifier
DESCRIPTION
Sets the QoS upstream/downstream bandwidth
profile.
: The QoS upstream/downstream
bwprofName
bandwidth profile name
ustype <0 ~ 5>: Specify the upstream
bandwidth group type the profile uses.
See bandwidth group types and how their
bandwidth is controlled by SIR, AIR, and PIR
parameters respectively in the following figure.
Figure 263 ONT Templates
sir<value>, air<value>,
pir<value>:
(in Kpbs).
Displays more information about the QoS
bandwidth profile.
Sets the QoS Call Admission Control (CAC)
profile which contains multicast bandwidth
settings. CAC is used to prevent oversubscription
of a VoIP network.
cacprofName
mcast-bw <kbps>
bandwidth
Displays more information about the QoS CAC
profile. CAC is used to prevent oversubscription
of a VoIP network.
Sets the downstream macro meter rate limit
sharing mode.
: the micro meter's Peak Information Rate
pir
(PIR) takes bandwidth first.
: the micro meter's Committed Information
cir
Rate (CIR) takes bandwidth first.
Configures a QoS ingress profile to map IEEE
802.1p priority tags to traffic classes.
ingprofName
DOT1P0TC<value>
mapping to priority
OLT2406 User's Guide
508
Sets the SIR, AIR, and PIR values
: The QoS CAC profile name
: Sets the multicast
: The QoS ingress profile name
: Sets the traffic class
M P
C 13
C 13
C 13
C 13
C 13
C 13