Arp Inspection Log Status - ZyXEL Communications OLT2406 User Manual

Figure 140 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
The following table describes the labels in this screen.
Table 88 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
LABEL
Show VLAN range
Enabled VLAN
Selected VLAN
Apply
VID
Received
Request
Reply
Forwarded
Dropped

27.8 ARP Inspection Log Status

Use this screen to look at log messages that were generated by ARP packets and that have not been
sent to the syslog server yet. To open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Log Status.
Chapter 27 IP Source Guard
DESCRIPTION
Use this section to specify the VLANs you want to look at in the section below.
Select this to look at all the VLANs on which ARP inspection is enabled in the section below.
Select this to look at all the VLANs in a specific range in the section below. Then, enter the
lowest VLAN ID (Start VID) and the highest VLAN ID (End VID) you want to look at.
Click this to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
This field displays the total number of ARP packets received from the VLAN since the OLT
last restarted.
This field displays the total number of ARP Request packets received from the VLAN since
the OLT last restarted.
This field displays the total number of ARP Reply packets received from the VLAN since the
OLT last restarted.
This field displays the total number of ARP packets the OLT forwarded for the VLAN since the
OLT last restarted.
This field displays the total number of ARP packets the OLT discarded for the VLAN since the
OLT last restarted.
OLT2406 User's Guide
236