Table of Contents
Advertisement
Table 306 DHCP Server Commands (continued)
COMMAND
no dhcp server <vlan-id> default-
gateway
no dhcp server <vlan-id> primary-
dns
no dhcp server <vlan-id> secondary-
dns
show dhcp server
show dhcp server <vlan-id>
Table 307 DHCP Client Test Commands
COMMAND
test dhcp-client start <aid> vlan
<snisvid> [nnisvid <1~4094>]
[snicvid <1~4094>] [ontid <1~128>]
[ontcardid <1~16>] [uniport
<1~128>] [ontsn <string>]
test dhcp-client stop <aid> <cr>
dhcp client-test timeout <1 to 180
seconds>
show dhcp client-test timeout
show dhcp client-test state <aid>
Chapter 82 DHCP
DESCRIPTION
Removes DHCP server default gateway
configuration for the specified VLAN.
Removes DHCP server primary DNS IP address
configuration for the specified VLAN.
Removes DHCP server secondary DNS IP address
configuration for the specified VLAN.
Displays DHCP server status.
Displays DHCP server status for the specified
VLAN.
DESCRIPTION
Starts a DHCP client test to simulate an ONT
getting IP address information from the DHCP
server.
aid: <ge|pon>-<slot>-<port> | slotge-
<slot>
snisvid: Choose Service Node Interface (SNI)
SVID on subscriber port (ONT), 1-4094. This is the
outer VLAN on the service node interface.
nnisvid: NNI SVID setting on subscriber port
(ONT), 1-4094. If this is not set and option 82
needs this value, it will show 4096. This is the outer
VLAN on the network to network interface.
snicvid: SNI CVID setting on subscriber port
(ONT), 1-4094. If this is not set and option 82
needs this value, it will show 4096. This is the inner
VLAN on the service node interface.
ontid: ONT ID to be added to option 82
information, 1-128
ontcardid: ONTCARD ID to be added to option
82 information, 1-16
uniport: UNIPORT value to be added to option
82 information, 1-128
ontsn: ONT serial number to be added to option
82 information, length 1-16
Stops a DHCP client test on the specified port.
aid: pon-<pon>
Specifies the DHCP client test timeout. The
default is 3 seconds.
Displays the DHCP client test timeout.
Displays the DHCP client test state of the
specified port.
aid: <ge|pon>-<slot>-<port> | slotge-
<slot>
OLT2406 User's Guide
592
M
P
C
13
C
13
C
13
E
13
E
13
M
P
E
13
E
13
C
13
E
3
E
3
Advertisement
Table of Contents
Troubleshooting
