Prohibiting Concurrent Logins; Changing The In-Band Management Ip Address; Changing The Out-Of-Band Management Ip Address - ZyXEL Communications OLT2406 User Manual

52.4 Prohibiting Concurrent Logins

By default the OLT allows multiple concurrent CLI sessions as follows.
Table 191 Access Control Overview
CONSOLE PORT
One session
Use no multi-login to prohibit concurrent logins and not allow a console port and Telnet access
control sessions to coexist. The console port has higher priority than Telnet.
OLT2406# configure
OLT2406(config)# no multi-login

52.5 Changing the In-band Management IP Address

The OLT has a different IP address in each VLAN. By default, the OLT has VLAN 1 with IP address
192.168.1.1 and subnet mask 255.255.255.0. Change the management IP address in a specific VLAN. This
example changes the management IP address in VLAN 1 to 172.16.0.1 with subnet mask 255.255.255.0.
OLT2406# configure
OLT2406(config)# vlan 1
OLT2406(config-vlan)# ip address 172.16.0.1 255.255.255.0
Note: Afterwards, you have to use the new IP address to access the OLT.

52.6 Changing the Out-of-band Management IP Address

This example changes the out-of-band management (MGMT port) IP address to 10.10.10.1 with subnet
mask 255.255.255.0 and default gateway 10.10.10.254
OLT2406# configure
OLT2406(config)# ip address 10.10.10.1 255.255.255.0
OLT2406(config)# ip address default-gateway 10.10.10.254
Chapter 52 Initial Setup
SSH TELNET
Share up to eight sessions
OLT2406 User's Guide
401
FTP SNMP
One session No limit