ZyXEL Communications OLT2406 User Manual page 712

Table 373 Port Bridge Commands (continued)
COMMAND
interface port-channel <aid>
port-bridge active <cr>
no port-bridge active <cr>
port-bridge mode <l2|ip> vlan-
list <vlist> [ip-subnet <ip>
<netmask>]
no port-bridge mode <cr>
show port-bridge <aid>
show interfaces config <aid> port-
bridge <cr>
Chapter 103 Port Bridge
DESCRIPTION
Enters config-interface mode for the specified
port(s).
aid: <ge|msc|pon>-<slot>-<port>
Enables the per-port-per-VLAN port bridge
feature on the specified port.
Disables the per-port-per-VLAN port bridge
feature on the specified port.
Configures the port bridge mode (l2 & ip) and
the VLAN group(s) for the per-port-per-VLAN
port bridge feature on the specified port.
mode <l2|ip>: Selects l2 to pass all kinds of
packets; selects ip to pass only IPv4 and ARP
packets.
[ip-subnet <ip> <netmask>]: Sets the IP
address and subnet mask of the ONT that the
port bridge mode settings will be applied to.
Removes the port bridge settings on the
specified port.
Displays if the per-port-per-VLAN port bridge
feature is enabled on the specified port or not.
aid: <ge|msc|pon>-<slot>-<port>
Displays the configuration information of per-
port-per-VLAN port bridge feature for the
specified port.
aid: slot-<slot> | <ge|msc|pon>-<slot>-
<port>
OLT2406 User's Guide
712
M P
C 13
C 13
C 13
C 13
C 13
E 3
E 13