Table of Contents
Advertisement
Figure 23 Opening a Transceiver Latch
2.7 Connect the Power
The chassis has two slots at the top of the front panel for redundant power supply modules (the OLT can
run on one). The power connections are on the front of each power module.
When connecting the OLT power wires to the power module, push the
wires firmly into the terminals as deep as possible and make sure that
no exposed (bare) wires can be seen or touched.
Use two (Or four) wires of the gauge specified in
DC power supply to supply the operating voltage for the OLT. It is recommended to connect input 1 to
Chapter 2 Hardware Installation
Table 388 on page 743
OLT2406 User's Guide
51
to connect each DC input to a
Advertisement
Table of Contents
Troubleshooting
