Power Maintenance; Procedure To Change A Power Module - ZyXEL Communications OLT2406 User Manual

3.3 Power Maintenance

This section describes how to change the power module. The power module has a built-in circuit
breaker. Before you replace a power module, make sure the circuit breaker is not causing the problem.

3.3.1 Procedure to Change a Power Module

The power module slots are at the upper right of the front panel of the chassis. Use the following
procedure to change a power module.
Obtain a new OLT power module from the manufacturer.
1
Turn off the power supply.
2
Loosen the power module thumbscrews and remove the power module from the OLT.
3
Remove the green power connector block from the front of the power module.
4
Push the power connector block into the front of the new power module.
5
Slide the power module into the OLT and tighten its thumbscrews.
6
Turn on the power supply.
7
Figure 32 Loosen the Power Module Thumbscrews
Chapter 3 Maintenance
OLT2406 User's Guide
59