Link Aggregation Control Protocol - ZyXEL Communications OLT2406 User Manual

The following table describes the labels in this screen.
Table 51 Advanced Application > Link Aggregation > Link Aggregation Setting
LABEL
Link
Aggregation
Setting
Group ID
Active
Criteria
Port
Group
Apply
Cancel

18.3.1 Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen
shown next. See
aggregation.
Chapter 18 Link Aggregation
DESCRIPTION
This is the only screen you need to configure to enable static link aggregation.
The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Select this option to activate a trunk group.
Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the OLT uses the src-dst-mac
distribution type. If the OLT is behind a router, the packet's destination or source MAC address will
be changed. In this case, set the OLT to distribute traffic based on its IP address to make sure port
trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
This field displays the port number.
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the OLT and configure port
security settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the OLT's run-time memory. The OLT loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Dynamic Link Aggregation on page 155
OLT2406 User's Guide
for more information on dynamic link
158