Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 163 Management > Maintenance
LABEL
Current
Config
Firmware
Upgrade
Restore
Configuration
Backup
Configuration
Load Factory
Default
Save
Configuration
Reboot System
43.3 Load Factory Default
Follow the steps below to reset the OLT back to the factory defaults.
Click the Click Her button next to the Load Factory Default field.
1
Click OK to continue or Cancel to abort.
2
Figure 213 Load Factory Default: Start
If you want to access the OLT web configurator again, you may need to change the IP address of your
computer to be in the same subnet as that of the default OLT IP address (192.168.1.1 or DHCP-assigned
IP).
43.4 Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on the OLT.
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the OLT.
Chapter 43 Maintenance
DESCRIPTION
This field displays which configuration (Configuration 1 or Configuration 2) is currently operating
on the OLT.
This field displays the firmware that was loaded to the OLT.
Click Click Here to go to the Firmware Upgrade screen.
Click Click Here to go to the Restore Configuration screen.
Click Click Here to go to the Backup Configuration screen.
Click Click Here to reset the current configuration of the OLT. Note that this will not reset the
configuration to the factory default settings.
Click Config 1 to save the current configuration settings to Configuration 1 on the OLT.
Click Config 2 to save the current configuration settings to Configuration 2 on the OLT.
Click Config 1 to reboot the system and load Configuration 1 on the OLT.
Click Config 2 to reboot the system and load Configuration 2 on the OLT.
Note: Make sure to click the Save button in any screen to save your settings to the
current configuration on the OLT.
OLT2406 User's Guide
348
Advertisement
Table of Contents
Troubleshooting
