Hardware Monitor Commands; External Alarm Commands - ZyXEL Communications OLT2406 User Manual

The following table describes the labels in this display.
Table 197 show timesync
LABEL
Time Zone
Time Sync Mode
Time Server IP Address
Time Server Sync Status

54.5 Hardware Monitor Commands

Use these commands to set the speeds for individual fans or set the fan speed to automatic.
Table 198 Hardware Monitor Commands
COMMAND
fan <0-100>
fan auto

54.6 External Alarm Commands

Use these commands to configure the external alarm features on the OLT.
Table 199 External Alarm Commands
COMMAND
kick tcp <session id>
external-alarm <index> name
<name_string>
no external-alarm <index>
Chapter 54 Basic Settings
DESCRIPTION
Displays the time zone.
Displays the time server protocol the OLT uses. It displays NO_TIMESERVICE if the time
server is disabled.
Displays the IP address of the time server.
Displays the status of the connection with the time server.
NONE: The time server is disabled.
CONNECTING: The OLT is trying to connect with the specified time server.
OK: Synchronize with time server done.
FAIL: Synchronize with time server fail.
DESCRIPTION
Specifies the fan module on which you want to
configure the fan speed.
Sets the fan's duty cycle percentage from
0~100%.
Sets the fan speed to automatic. The fan speed
is adjusted automatically according to
temperatures sensed by the hardware monitor
IC.
DESCRIPTION
Disconnects the specified TCP session.
session id
the show ip tcp command.
Sets the name of the specified external alarm.
index
name_string
characters.
Removes the name of the specified external
alarm input.
OLT2406 User's Guide
416
: Display the session ID by running
: 1 ~ 4
: Enters a name of up to 32 ASCII
M P
E
E
M P
E 13
C 13
C 13