Protocol Based Vlan Commands - ZyXEL Communications OLT2406 User Manual

Figure 252 Protocol Based VLAN Application Example

56.13.1 Protocol Based VLAN Commands

The following section lists the commands for this feature.
Table 225 Protocol Based VLAN Commands
COMMAND
show interfaces config <aid>
protocol-based-vlan
interface port-channel <aid>
protocol-based-vlan name
<name> ethernet-type <ether-
num|ip|ipx|arp|rarp|appletalk|
decnet> vlan <vlan-id>
priority <0-7>
DESCRIPTION
Displays the protocol based VLAN settings for
the specified port(s).
aid: slot-<slot> | <ge|msc|pon>-<slot>-
<port>
Enters sub-command mode for configuring the
specified ports.
aid: slot-<slot> | <ge|msc|pon>-<slot>-
<port>
Creates a protocol based VLAN with the
specified parameters.
name: Use up to 32 alphanumeric characters.
ether-num: If you don't select a predefined
Ethernet protocol (ip, ipx, arp, rarp,
appletalk or decnet), type the protocol
number in hexadecimal notation with a prefix,
"0x". For example, type "0x0800" for the IP
protocol and type "0x8137" for the Novell IPX
protocol.
Note: Protocols in the hexadecimal
number range 0x0000 to 0x05ff are
not allowed.
priority: Specify the IEEE 802.1p priority that
the OLT assigns to frames belonging to this VLAN.
OLT2406 User's Guide
453
M P
E 3
C 13
C 13