Table of Contents
Advertisement
Table 313 OSPF Command Summary (continued)
COMMAND
passive-iface <ip-addr/bits>
no passive-iface <ip-addr/
bits>
summary-address <ip-addr>
<mask>
no summary-address <ip-add>
<mask>
no router ospf
83.3 Command Examples
In this example, the OLT (A) is an Area Border Router (ABR) in an OSPF network.
Figure 281 OSPF Network Example
This example enables OSPF on the OLT, sets the router ID to 172.16.1.1, configures an OSPF area ID as
0.0.0.0 (backbone) and enables simple authentication.
sysname(config)# router ospf 172.16.1.1
sysname(config-ospf)# area 0.0.0.0
sysname(config-ospf)# area 0.0.0.0 authentication
sysname(config-ospf)# area 0.0.0.0 name backbone
sysname(config-ospf)# network 172.16.1.1/24 area 0.0.0.0
sysname# show router ospf area
index:1
area-id:0.0.0.0
stub-active:N stub-no-sum:N
Chapter 83 OSPF Commands
active:Y
name:backbone
auth:SIMPLE
default-cost:15
OLT2406 User's Guide
604
DESCRIPTION
Sets the interface to be passive.
A passive interface does not send or receive
hello packets in the OSPF network. If hello
packets can't be sent out from the passive
interface, a neighbor relationship won't be
formed. Thus, this prevents attackers to have
access in the OSPF network.
Sets the interface to not be passive.
Sets a summary address which is a network IP
address used to cover more than one network
routing entry in order to reduce the routing table
size.
Removes a summary address.
Disables OSPF on the OLT.
M
P
C
13
C
13
C
13
C
13
C
13
Advertisement
Table of Contents
Troubleshooting
