Gvrp Command Examples; Port Vlan Trunking - ZyXEL Communications OLT2406 User Manual

56.9.1 GVRP Command Examples

This example shows the OLT's GVRP settings.
OLT2406# show vlan1q gvrp
GVRP Support
-----------------------
gvrpEnable = YES
gvrpPortEnable:
This example turns off GVRP on ports ge-5-1 ~ ge-5-4.
OLT2406# configure
OLT2406(config)# interface port-channel ge-5-1&&-4
OLT2406(config-interface)# no gvrp
OLT2406(config-interface)# exit
OLT2406(config)# exit

56.10 Port VLAN Trunking

Enable VLAN trunking on a port to allow frames belonging to unknown VLAN groups to pass through
that port. This is useful if you want to set up VLAN groups on end devices without having to configure the
same VLAN groups on intermediary devices.
The following figure describes VLAN trunking. Suppose you want to create VLAN groups 1 and 2 (V1 and
V2) on devices A and B. Without VLAN trunking, you must configure VLAN groups 1 and 2 on all
intermediary switches C, D and E; otherwise they will drop frames with unknown VLAN group tags.
However, with VLAN trunking enabled on a port(s) in each intermediary switch you only need to create
VLAN groups in the end devices (A and B). C, D and E automatically allow frames with VLAN group tags
1 and 2 (VLAN groups that are unknown to those switches) to pass through their VLAN trunking port(s).
Figure 250 Port VLAN Trunking
A
V1 V2 V1 V2
Chapter 56 VLAN
C
D
OLT2406 User's Guide
449
E
B
V1 V2