Setting Port Vid - ZyXEL Communications OLT2406 User Manual

In the Static VLAN screen, select ACTIVE, enter a
2
descriptive name in the Name field, enter 2 in the
VLAN Group ID field for the VLAN5 network, and use
the default VLAN type, Normal, in the VLAN Type field.
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup screen refer to the
same VLAN ID.
Since the VLAN5 network is connected to port 10 on the OLT, select Fixed to configure port 10 to be a
3
permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
4
the TX Tagging check box to set the OLT to remove VLAN tags before sending.
Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost when the
5
OLT's power is turned off.

5.1.2 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 5 as the port VID on port 10 so that any untagged frames received
on that port get sent to VLAN 5.
See Table 21 on page 86 about mappings of VLAN ports and physical ports.
Chapter 5 Initial Setup Example
OLT2406 User's Guide
73