Mstp Command Examples - ZyXEL Communications OLT2406 User Manual

Table 238 MSTP Instance Commands (continued)
COMMAND
mstp instance <0-16> interface
port-channel <aid> path-cost <1-
65535>
mstp instance <0-16> interface
port-channel <aid> priority <0-
255>

63.4.1 MSTP Command Examples

This example shows the current MSTP configuration.
OLT2406# show mstp
(a)BridgeMaxAge:
(b)BridgeHelloTime:
(c)BridgeForwardDelay:
(d)BridgeMaxHops:
(e)TransmissionLimit:
(f)ForceVersion:
(g)MST Configuration ID
Format Selector:
Configuration Name:
Reveision Number:
Configuration Digest:
msti
-----------------------------
0
-----------------------------
The following table describes the labels in this display.
Table 239 show mstp
LABEL
BridgeMaxAge
BridgeHelloTime
BridgeForwardDelay
BridgeMaxHops
TransmissionLimit
ForceVersion
MST Configuration ID
Format Selector
Configuration Name
20
2
15
128
3
3
0
001349aefb7a
0
0xAC36177F50283CD4B83821D8AB26DE62
vlans mapped
1-4094
DESCRIPTION
This field displays the maximum time (in seconds) the OLT can wait without receiving a
configuration message before attempting to reconfigure.
This field displays the time interval (in seconds) at which the OLT transmits a
configuration message.
This field displays the time (in seconds) the OLT will wait before changing states (that is,
listening to learning to forwarding).
This field displays the number of hops (in seconds) in an MSTP region before the BPDU is
discarded and the port information is aged.
This field displays the maximum number of BPDUs that can be transmitted in the interval
specified by BridgeHelloTime.
This field indicates whether BPDUs are RSTP (a value less than 3) or MSTP (a value
greater than or equal to 3).
This field displays zero, which indicates the use of the fields below.
This field displays the configuration name for this MST region.
OLT2406 User's Guide
478
DESCRIPTION
Specifies the cost of transmitting a frame to a
LAN through the port(s). It is recommended you
assign it according to the speed of the bridge.
aid: msc-<slot>-<port>
Sets the priority for the specified ports. Priority
decides which port should be disabled when
more than one port forms a loop in a OLT. Ports
with a higher priority numeric value are disabled
first.
aid: msc-<slot>-<port>
(seconds)
(seconds)
(seconds)
M P
C 13
C 13