Link Aggregation Commands Examples - ZyXEL Communications OLT2406 User Manual

Table 249 LACP Commands (continued)
COMMAND
no lacp
lacp system-priority <1-65535>

68.4 Link Aggregation Commands Examples

This example activates trunk 1 and places ports msc-1-1 and msc-1-2 in the trunk using static link
aggregation.
OLT2406(config)# trunk T1
OLT2406(config)# trunk T1 interface msc-1-1&&-2
This example disables trunk one (T1) and removes ports msc-1-3 and msc-1-4 from trunk two (T2).
OLT2406(config)# no trunk T1
OLT2406(config)# no trunk T2 interface msc-1-3&&-4
This example displays the current trunks.
OLT2406(config)# exit
OLT2406# show trunk
Group ID T1:
Criteria :
Status: LACP
Member number: 2
Group ID T2:
Criteria :
Status: Static
Member number: 2
The following table describes the labels.
Table 250 Show Trunk Labels
LABEL
Group ID
Status
Chapter 68 Link Aggregation
active
src-dst-mac
Member: [msc-1-1]-[msc-1-2]
active
src-dst-mac
Member: [msc-1-3]-[msc-1-4]
DESCRIPTION
This field displays the trunk ID number and the current status.
inactive: This trunk is disabled.
active: This trunk is enabled.
This field displays how the ports were added to the trunk.
-: The trunk is disabled.
Static: The ports are static members of the trunk.
LACP: The ports joined the trunk via LACP.
OLT2406 User's Guide
DESCRIPTION
Disables the link aggregation control protocol
(Dynamic trunking) on the OLT.
Sets the priority of an active port using LACP.
491
M P
C 13
C 13