Table of Contents
Advertisement
Table 294 VoIP Common Profile Commands (continued)
COMMAND
2nd-packet-period <10-30>
2nd-silence <enable|disable>
3rd-codec <encoding name>
3rd-packet-period <10-30>
3rd-silence <enable|disable>
4th-codec <encoding name>
4th-packet-period <10-30>
4th-silence <enable|disable>
announce-type <silence|reo-
ton|fas-bus|voi-ann>
cas <enable|disable>
dscp-mark <0~63>
dtmf <enable|disable>
echo-cancel <enable|disable>
fax-mode <passthru|T38>
Chapter 78 VoIP
DESCRIPTION
Specifies the second packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
Turns the use of silence suppression with the
second codec on or off.
Specifies the third audio codec to tell the
remote ONT. The remote ONT must use the same
codec as the peer. The options are the same as
described for the first codec.
Specifies the third packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
Turns the use of silence suppression with the third
codec on or off.
Specifies the fourth audio codec to tell the
remote ONT. The remote ONT must use the same
codec as the peer. The options are the same as
described for the first codec.
Specifies the fourth packet period selection
interval (In milliseconds). This value is useful when
the media gateway controller does not provide
the preferred compression algorithm and
packet period parameter to the ONT. The range
depends on the type of codec selected.
Turns the use of silence suppression with the
fourth codec on or off.
Sets the treatment for when a subscriber goes
off-hook. Here are the options and what they
represent.
silence: Silence
reo-ton: Reorder tone
fas-ton: Fast busy
voi-ann: Voice announcement
Enables or disables handling of DTMF via RTP cas
events as defined in RFC 4733.
Specifies the Diffserv code point (From 0 to 63)
to use for outgoing RTP packets.
Enables or disables handling of DTMF via RTP
DTMF events as defined in RFC 4733.
Enables or disables echo cancellation.
Sets how to handle faxes. Use passthru to
transmit faxes as voice (in-band). Use T38 to
transmit faxes as separate packets (out-of-
band) according to ITU-T T.38.
OLT2406 User's Guide
564
M
P
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
Advertisement
Table of Contents
Troubleshooting
