Table of Contents
Advertisement
Figure 191 Advanced Application > ONT Template > ONT ACL > ACL Profile Setting
The following table describes the labels in this screen.
Table 138 Advanced Application > ONT Template > ONT ACL > ACL Profile Setting
LABEL
DESCRIPTION
Name
Enter a descriptive name that identifies the ACL profile.
Active
Select Yes to enable the ACL profile.
Select No to disable the ACL profile.
Policy
Select Drop to drop the incoming traffic when the traffic matches the rules.
Select Trust to forward the incoming traffic when the traffic matches the rules.
Select or clear the Counter check box to enable or disable packet counting for the ACL profile.
Select or clear the Logging check box to enable or disable packet logging for the ACL profile.
Interface
Select an interface (LAN, WAN, or BOTH) that the rules will be applied to.
Layer 2
Specify the fields below to configure a layer 2 classifier.
Source
MAC
Select Any to apply the rule to all MAC addresses.
Address
Select MAC to enter the source MAC address of the packet in valid MAC address format (six
hexadecimal character pairs).
Destination
MAC
Select Any to apply the rule to all MAC addresses.
Address
Select MAC to enter the destination MAC address of the packet in valid MAC address format (six
hexadecimal character pairs).
Layer 3/4
Specify the fields below to configure a layer 3 and layer 4 classifier.
IP Protocol
Enter the protocol number in decimal value. Refer to
information.
Source
Chapter 38 ONT Template
OLT2406 User's Guide
315
Section Table 139 on page 317
for more
Advertisement
Table of Contents
Troubleshooting
