Table of Contents
Advertisement
2.1 Overview
This chapter describes how to install and connect the OLT and line cards. It also includes installation
instructions and descriptions of the OLT chassis and line card components, such as transceivers and
power modules.
2.2 General Installation Instructions
Perform the installation as follows:
• Make sure the OLT's power switches are in the OFF position.
• Install the chassis as detailed in
before you make any other connections.
• Have qualified service personnel install the OLT in a restricted access area, such as a street cabinet or
data center.
• See
Section 2.4 on page 45
• Leave the slot covers on unused slots.
• See
Section 2.7 on page 51
2.3 Chassis Installation
This section explains how to install the chassis on a rack.
2.3.1 Rack-mounted Installation Requirements
Make sure the rack will safely support the combined weight of all the equipment it contains.
• Use a #2 Phillips screwdriver to install the screws.
• Refer to
Section 110.2 on page 742
• Refer to
Section 110.1 on page 741
Failure to use the proper screws may damage the unit.
Hardware Installation
Section 2.3 on page
to install management and line cards.
to make power connections and turn on the OLT.
for the gauge of wire to use for the frame ground connections.
for the OLT's dimensions, weight and power consumption.
OLT2406 User's Guide
C
H A P T E R
43, making sure you connect the frame grounds
43
2
Advertisement
Table of Contents
Troubleshooting
