Vlan Commands - ZyXEL Communications OLT2406 User Manual

OLT2406 (config)# vlan 2000
OLT2406 (config-vlan)# name up1
OLT2406 (config-vlan)# fixed ge-5-1&&-4
OLT2406 (config-vlan)# no untagged ge-5-1&&-4
OLT2406 (config-vlan)# exit
OLT2406 (config)# interface port-channel ge-5-1&&-4
OLT2406 (config-interface)# pvid 2000
OLT2406 (config-interface)# exit
Note: See Section 54.10 on page 421

56.6 VLAN Commands

The following section lists the commands for this feature.
Table 216 VLAN Commands
COMMAND
interface port-channel <aid>
pvid <1-4094>
frame-type
<all|tagged|untagged>
show vlan
show vlan <vlan-id>
modify-vlan2 <0|1>
vlan-type <802.1q>
vlan <vlan-id>
Chapter 56 VLAN
for interface port-channel commands.
DESCRIPTION
Enters config-interface mode for configuring the
specified port(s).
: <ge|msc|pon>-<slot>-<port>
aid
Sets the specified interface's PVID.
Chooses to accept both tagged and untagged
incoming frames (
frames (
tagged
frames on a port (
Displays the status of all VLANs.
Displays the status of the specified VLAN.
VLAN 2 is a special VLAN used for Port Address
Translation (PAT). It must be enabled to make
PAT work.
By using PAT, the administrator can access the
ONT's web configurator directly from links built in
the OLT's web configurator.
For the OLT, VLAN 2 is fixed in the default settings
and cannot be modified by default. If you need
to modify the configuration of VLAN 2, use this
special execution mode command to enable or
disable VLAN 2 modification.
0: disable
1: enable
Specifies the VLAN type. Currently the OLT
supports IEEE 802.1q VLAN.
Enters config-vlan mode for the specified VLAN.
Creates the VLAN, if necessary.
OLT2406 User's Guide
442
), just tagged incoming
all
) or just untagged incoming
).
untagged
M P
C 13
C 13
C 13
E 3
E 3
C 13
C 13
C 13