Uni Port Settings; Uni Port General Commands - ZyXEL Communications OLT2406 User Manual

96.4 UNI Port Settings

Use these commands to configure settings on individual UNI ports (ports on the subscriber devices). See
Section 78.5 on page 570

96.4.1 UNI Port General Commands

These commands apply to any UNI port.
Table 354 UNI Port General Command Parameters
LABEL
no remote uniport all
no remote uniport <aid>
remote uniport <aid>
inactive
no inactive
ipbinding vlan <vlan> ip <ip>
no ipbinding <cr>
pmenable <cr>
pmenable 32-bit
pmenable 64-bit
no pmenable
port-speed <auto|10-full|100-
full|1000-full|2.5G-full>
and Section 78.6 on page 571
DESCRIPTION
Removes all UNI port configuration.
Removes UNI port configuration for the specified
UNI port.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
Please select the corresponding card ID
according to the desired card type.
Card 1: 10_100_1000BASET
Card 2: VEIP
Card 3: POTS
Card 4: VIDEO
Card 5: 10_100BASET
Card 6: 10_100_1000BASET_VEIP
Deactivates the specified UNI port.
Activates the specified UNI port.
Configures a range of IP addresses for the
specified ONT.
Note: Remember to enable static IP
Removes the static IP binding configuration of
the remote ONTs connected to the specified
UNI port.
Enables PM (performance monitoring) to get
counters on the specified UNI port.
Enables PM (performance monitoring) to get 32-
bit counters on the specified UNI port.
Enables PM (performance monitoring) to get 64-
bit counters on the specified UNI port.
Disables PM (performance monitoring) to get
counters on the specified UNI port.
Sets the auto detection configuration attribute
in the physical path termination point Ethernet
UNI ME as defined in G984.4. Use auto ora
specific rate and duplex mode.
OLT2406 User's Guide
673
for UNI port VoIP commands.
binding using the remote ont
<aid> ipbinding <cr> command.
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13