Snmp Server Commands - ZyXEL Communications OLT2406 User Manual

Table 321 SNMP Switch Traps
OPTION OBJECT LABEL
stp STPNewRoot
MSTPNewRoot
STPTopologyChange
rmon RmonRisingAlarm
RmonFallingAlarm
cfm dot1agCfmFaultAlarm

85.3 SNMP Server Commands

Use these commands to configure SNMP on the OLT.
The following table describes user-input values available in multiple commands for this feature.
Table 322 SNMP Server Commands User-input Values
COMMAND
property
options
The following section lists the commands for this feature.
Table 323 SNMP Server Commands
COMMAND
show snmp-server
snmp-server <[contact <system-
contact>] [location <system-
location>]>
Chapter 85 Access Control
OBJECT ID
1.3.6.1.2.1.17.0.1
1.3.6.1.4.1.890.1.5.17.3.107.70.1
1.3.6.1.2.1.17.0.2
1.3.6.1.4.1.890.1.5.1.1.16.0.1
1.3.6.1.4.1.890.1.5.1.1.16.0.2
1.3.111.2.802.1.1.8.0.1
DESCRIPTION
Displays SNMP settings.
Sets the geographic location and the name of
the person in charge of this OLT.
system-contact: 1-32 English keyboard
characters; spaces are allowed.
system-location: 1-32 English keyboard
characters; spaces are allowed.
OLT2406 User's Guide
614
DESCRIPTION
This trap is sent when the STP root switch changes.
This trap is sent when the MSTP root switch
changes.
This trap is sent when the STP topology changes.
This trap is sent when a variable goes over the
RMON "rising" threshold.
This trap is sent when the variable falls below the
RMON "falling" threshold.
The trap is sent when the OLT detects a
connectivity fault.
DESCRIPTION
1-32 alphanumeric characters
aaa: authentication, accounting.
interface: linkup, linkdown,
autonegotiation, lldp, transceiver-ddm.
ip: ping, traceroute.
switch: stp, mactable, rmon, cfm.
system: coldstart, warmstart, fanspeed,
temperature, voltage, reset, timesync,
intrusionlock, loopguard, poe.
M P
E 3
C 13