Table of Contents
Advertisement
Figure 21 Pulling the Card Out
2.5 Transceiver Installation
Use the following steps to install an SFP or SFP+ module in a slot.
For slots that are at an angle; do not attempt to straighten it.
Remove the dust cover from the transceiver.
1
For transceivers with a flip-up or flip-down latch, close the latch.
2
Insert the fiber-optic cables into the transceiver (you may need to remove the cable dust covers).
3
Insert the transceiver into the slot with the exposed section of PCB board facing down.
4
Press the transceiver firmly until it clicks into place.
5
Chapter 2 Hardware Installation
OLT2406 User's Guide
49
Advertisement
Table of Contents
Troubleshooting
