Protocol Based Vlan Command Examples - ZyXEL Communications OLT2406 User Manual

Table 225 Protocol Based VLAN Commands (continued)
COMMAND
protocol-based-vlan name
<name> ethernet-type <ether-
num|ip|ipx|arp|rarp|appletalk|
decnet> vlan <vlan-id>
priority <0-7> inactive
no protocol-based-vlan
ethernet-type <ether-
num|ip|ipx|arp|rarp|appletalk|
decnet>

56.13.2 Protocol Based VLAN Command Examples

This example creates a VLAN rule based on the IP Ethernet protocol and named IP_VLAN on ports ge-5-
1 ~ ge-5-4 with a VLAN ID of 200 and a priority 6.
See Table 29 on page 120
OLT2406(config)# interface port-channel ge-5-1&&-4
OLT2406(config-interface)# protocol-based-vlan name IP_VLAN ethernet-type ip
vlan 200 priority 6
OLT2406(config-interface)# exit
OLT2406(config)# exit
OLT2406# show interfaces config ge-5-1&&-4 protocol-based-vlan
Name
-------
IP_VLAN
IP_VLAN
IP_VLAN
IP_VLAN
for the mappings of the port number and the physical ports.
Port Packet type Ethernet type
---- ----------- -------------
9 EtherII
10 EtherII
11 EtherII
12 EtherII
OLT2406 User's Guide
Chapter 56 VLAN
DESCRIPTION
Creates a disabled protocol based VLAN with
the specified parameters.
name: Use up to 32 alphanumeric characters.
ether-num: If you don't select a predefined
Ethernet protocol (ip, ipx, arp, rarp,
appletalk or decnet), type the protocol
number in hexadecimal notation with a prefix,
"0x". For example, type 0x0800 for the IP protocol
and type 0x8137 for the Novell IPX protocol.
Note: Protocols in the hexadecimal
number range 0x0000 to 0x05ff are
not allowed.
priority: Specify the IEEE 802.1p priority that
the OLT assigns to frames belonging to this VLAN.
Disables protocol based VLAN of the specified
protocol on the port.
Vlan
----
ip 200
ip 200
ip 200
ip 200
454
Priority Active
-------- ------
6 Yes
6 Yes
6 Yes
6 Yes
M P
C 13
C 13