Table of Contents
Advertisement
44.3 Configuring SNMP
Use this screen to configure your SNMP settings.
Click Management > Access Control > SNMP to view the screen as shown.
Figure 219 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 167 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
Set Community
Trap Community
Trap Destination
Version
IP
Port
Chapter 44 Access Control
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the OLT. The SNMP version on the OLT must match the version on
the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both (v3v2c).
SNMP version 2c is backwards compatible with SNMP version 1.
Enter the Get Community string, which is the password for the incoming Get- and GetNext-
requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or lower.
Enter the Set Community, which is the password for incoming Set- requests from the
management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or lower.
Enter the Trap Community string, which is the password sent with each trap to the SNMP
manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or lower.
Use this section to configure where to send SNMP traps from the OLT.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
OLT2406 User's Guide
355
Advertisement
Table of Contents
Troubleshooting
