Table of Contents
Advertisement
Table 76 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL
Delete
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Apply
Cancel
26.4 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See
more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the AAA screen to view
the screen as shown.
Figure 131 Advanced Application > AAA > TACACS+ Server Setup
Chapter 26 AAA
DESCRIPTION
Check this box if you want to remove an existing RADIUS server entry from the OLT. This entry is
deleted when you click Apply.
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the OLT waits for an accounting request response
from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
The default port of a RADIUS accounting server for accounting is 1813. You need not change
this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS accounting server and the OLT. This key is not sent over the network. This key
must be the same on the external RADIUS accounting server and the OLT.
Check this box if you want to remove an existing RADIUS accounting server entry from the OLT.
This entry is deleted when you click Apply.
Click Apply to save your changes to the OLT's run-time memory. The OLT loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
OLT2406 User's Guide
RADIUS and TACACS+ on page 215
217
for
Advertisement
Table of Contents
Troubleshooting
