Table of Contents
Advertisement
14.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the OLT. Click
Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 83 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 38 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
14.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see
Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Chapter 14 Spanning Tree Protocol
DESCRIPTION
You can activate one of the STP modes on the OLT.
Select Rapid Spanning Tree or Multiple Spanning Tree. See
background information on STP.
Click Apply to save your changes to the OLT's run-time memory. The OLT loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
OLT2406 User's Guide
134
Section 14.1 on page 131
Section 14.1 on page 131
for
for more information on RSTP.
Advertisement
Table of Contents
Troubleshooting
