Table of Contents
Advertisement
Table 73 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL
Delete
Delete
Cancel
25.4.5 MVR Group Configuration
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this
multicast group.
Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration link in the
MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Figure 127 Advanced Application > Multicast > Multicast Setting > MVR > Group Configuration
The following table describes the labels in this screen.
Table 74 Advanced Application > Multicast > Multicast Setting > MVR > Group Configuration
LABEL
Multicast VLAN
ID
Name
Start Address
End Address
Chapter 25 Multicast
DESCRIPTION
Select an entry's check box to select a specific entry.
To delete a multicast VLAN(s), select the rule(s) that you want to remove, then click the Delete
button.
Click Cancel to clear the check boxes.
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
Section 25.1.2 on page 197
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP address
for a multicast group.
Refer to
Section 25.1.2 on page 197
OLT2406 User's Guide
for more information on IP multicast addresses.
for more information on IP multicast addresses.
212
Advertisement
Table of Contents
Troubleshooting
