Table of Contents
Advertisement
Table 158 IP Application > DHCP > VLAN (continued)
LABEL
Server
Client IP Pool
Starting Address
Size of Client IP
Pool
IP Subnet Mask
Default
Gateway
Primary/
Secondary DNS
Server
Relay
Remote DHCP
Server 1 .. 3
Relay Agent
Information
Format
Information
Add
Cancel
Clear
VID
Type
DHCP Status
Delete
Delete
Cancel
42.5 DHCP L2 Agent
Use this screen to configure the DHCP relay agent information and Lightweight DHCPv6 Relay Agent
(LDRA) settings. Click IP Application > DHCP in the navigation panel, then click the Option link In the
DHCP Status screen that displays.
See
Section 27.10.1.4 on page 243
82 settings in different screens.
Chapter 42 DHCP
DESCRIPTION
Specify the first of the contiguous addresses in the IP address pool.
Specify the size of the IP address pool.
Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default).
Enter the default gateway of the OLT.
Enter the primary/secondary DNS server IP address for the OLT.
Use this section if you want to configure the OLT to function as a DHCP relay for this VLAN.
Enter the IP address of a DHCP server in dotted decimal notation.
Select Option 82 to have the OLT add information (slot number, port number and VLAN ID) and
the Circuit ID and Remote ID sub-options to client DHCP requests that it relays to a DHCP server.
Select this to have the OLT use the default Circuit ID format for DHCP packets.
Enter a string of up to 32 ASCII or binary characters that the OLT adds into the client DHCP
requests. Spaces are allowed.
Otherwise, use the system name you configure in the General Setup screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the OLT's run-time memory. The OLT loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This field displays the ID number of the VLAN group to which this DHCP settings apply.
This field displays Server or Relay for the DHCP mode.
For DHCP server configuration, this field displays the starting IP address and the size of the IP
address pool.
For DHCP relay configuration, this field displays the first remote DHCP server IP address.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select the configuration entries you want to remove and click Delete to remove them.
Click Cancel to clear the check boxes.
for more information about the configuration order for DHCP option
OLT2406 User's Guide
339
Advertisement
Table of Contents
Troubleshooting
