Link Aggregation Status - ZyXEL Communications OLT2406 User Manual

• You must connect all ports point-to-point to the same Ethernet switch and configure the ports for
LACP trunking.
• LACP only works on full-duplex links.
• All ports in the same trunk group must have the same media type, speed, duplex mode and flow
control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
Link Aggregation ID
LACP aggregation ID consists of the following information
Table 48 Link Aggregation ID: Local Switch
SYSTEM PRIORITY
0000
Table 49 Link Aggregation ID: Peer Switch
SYSTEM PRIORITY
0000

18.2 Link Aggregation Status

Click Advanced Application > Link Aggregation in the navigation panel. The Link Aggregation Status
screen displays by default. See
Figure 97 Advanced Application > Link Aggregation
The following table describes the labels in this screen.
Table 50 Advanced Application > Link Aggregation
LABEL
Group ID
Enabled Ports
Synchronized
Ports
1. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Chapter 18 Link Aggregation
MAC ADDRESS
00-00-00-00-00-00
MAC ADDRESS
00-00-00-00-00-00
Section 18.1 on page 155
DESCRIPTION
This field displays the group ID to identify a trunk group, that is, one logical link containing multiple
ports.
These are the ports you have configured in the Link Aggregation screen to be in the trunk group.
The port number(s) displays only when this trunk group is activated and there is a port belonging
to this group.
These are the ports that are currently transmitting data as one logical link in this trunk group.
OLT2406 User's Guide
1
:
KEY PORT PRIORITY
0000 00
KEY PORT PRIORITY
0000 00
for more information.
156
PORT NUMBER
0000
PORT NUMBER
0000