ZyXEL Communications OLT2406 User Manual page 541

Table 276 IGMP Commands on Interface Port Channel (continued)
COMMAND
mcast-channel <start-group-ip>
<end-group-ip> vlan <1-4094>
[active <on|off>]
[pbit <0-7>]
[name <groupname>]
[src-ip <ip>]
[package-member <1-32>]
[preview-duration <sec>]
[preview-count <count>]
[preview-blackout <sec>]
[cacprof <prof>]
Chapter 76 Multicast
DESCRIPTION
Configures a GPON client multicast channel.
See Section 96.4.6 on page 684
multicast channels to the IGMP channel of a
uniport of the ONT.
start-group-ip
the multicast IP address range. The range of
addresses must be between 224.0.0.0 and
239.255.255.255.
end-group-ip
multicast IP address range. The range of
addresses must be between 224.0.0.0 and
239.255.255.255.
vlan: 1 ~ 4094. Configures an MVR.
active: Use "on" to activate this CLI
configuration and, for any remote ONT UNI port
adapting this package member, provision OMCI
to the ONT.
pbit: 0 ~ 7. Sets the IEEE 802.1p priority level to
add to the untagged frames of this multicast
channel.
: Configures the name of the
groupname
multicast channel.
src-ip: Configures the source IP of the IGMP
server supplying this range of groups.
: 1 ~ 32. Assigns an ID number to this
package
multicast channel. Subscribers will be able to
order package members according to this
identifier.
preview-duration <
Configures the duration that a subscriber can
join to a group. This field is meaningful only when
this multicast channel is ordered by subscribers
with preview privilege.
preview-count <
the maximum number of times a subscriber can
preview this multicast channel's content. This
field is meaningful only when this multicast
channel is ordered by subscribers with preview
privilege.
preview-blackout <
Configures the duration that a subscriber has to
wait between 2 times of previewing a group. This
field is meaningful only when this multicast
channel is ordered by subscribers with preview
privilege.
cacprof <prof>: Specify the QoS CAC profile
which contains multicast bandwidth settings
and is created by the qos cacprof command.
Note: An MVR group will be created
automatically by the OLT, after a
GPON client multicast channel was
created.
OLT2406 User's Guide
541
for associating
: The beginning IP address of
: The ending IP address of the
>: 1 ~ 6000.
sec
>: 1 ~ 100. Configures
count
>: 0 ~ 7200.
sec
M P
C 13