97.2.1 Management Switching Card Control Commands Examples
This example displays management switching card state and firmware version information from
execution mode.
OLT2406(config)# msc
Slot
State
-------------------------------------
*1
active
2
-
next boot: 1
Update target: All
This example displays management switching card state and firmware version information from
configuration mode.
OLT2406# configure
OLT2406(config)# msc
Slot
State
-------------------------------------
*1
active
2
-
next boot: 1
Update target: All
This example copies the active management switching card's running firmware to the standby
management switching card's running firmware.
OLT2406# configure
OLT2406(config)# msc sync ras
...........................................................
OLT2406(config)# send ras to standby msc...
########################################
97.3 Port-level Protect Switch Commands
With port-level protect-switch enabled, the active MSC changes roles to stand-by mode if all uplink port
links go down. The following section lists the commands for this feature.
Table 365 Port-level Protect Switch Commands
COMMAND
show protect-switch msc
protect-switch msc port-level
enable
no protect-switch msc port-level
enable
Chapter 97 Management Switching Card Control
Update
F/W Ver.
v
V4.00(AAOP.1)C0 | 2015-02-03
v
Update
F/W Ver.
v
V4.00(AAOP.1)C0 | 2015-02-03
v
OLT2406 User's Guide
689
DESCRIPTION
Displays the port-level protect-switch
configuration. See
Chapter 98 on page 691
information about protect-switch groups.
Turns on port-level protection.
Disables port-level protection.
M
P
E
3
for
C
13
C
13