Dma Control Register (Dcon) - Samsung S3C2416 User Manual

DMA CONTROLLER

4.5 DMA CONTROL REGISTER (DCON)

Register
DCON0 0x4B000010
DCON1 0x4B000110
DCON2 0x4B000210
DCON3 0x4B000310
DCON4 0x4B000410
DCON5 0x4B000510
DCONn Bit
DMD_HS [31]
SYNC [30]
INT [29]
TSZ [28]
SERVMODE [27]
8-12
Address R/W
R/W DMA0 Control Register
R/W DMA1 Control Register
R/W DMA2 Control Register
R/W DMA3 Control Register
R/W DMA4 Control Register
R/W DMA5 Control Register
Select one between demand mode and handshake mode.
0 = demand mode is selected
1 = handshake mode is selected.
In both modes, DMA controller starts its transfer and asserts DACK
for a given asserted DREQ. The difference between two modes is
whether it waits for the de-asserted DACK or not. In handshake
mode, DMA controller waits for the de-asserted DREQ before
starting a new transfer. If it sees the de-asserted DREQ, it de-
asserts DACK and waits for another asserted DREQ. In contrast, in
the demand mode, DMA controller does not wait until the DREQ is
de-asserted. It just de-asserts DACK and then starts another
transfer if DREQ is asserted. We recommend using handshake
mode for external DMA request sources to prevent unintended
starts of new transfers.
Select DREQ/DACK synchronization.
0 = DREQ and DACK are synchronized to PCLK (APB clock).
1 = DREQ and DACK are synchronized to HCLK (AHB clock).
Therefore, devices attached to AHB system bus, this bit has to be
set to 1, while those attached to APB system, it should be set to 0.
For the devices attached to external system, user should select this
bit depending on whether the external system is synchronized with
AHB system or APB system.
Enable/Disable the interrupt setting for CURR_TC(terminal count)
0 = CURR_TC interrupt is disabled. User has to look the transfer
count in the status register. (i.e., polling)
1 = Interrupt request is generated when all the transfer is done (i.e.,
CURR_TC becomes 0).
Select the transfer size of an atomic transfer (i.e., transfer
performed at each time DMA owns the bus before releasing the
bus).
0 = A unit transfer is performed.
1 = A burst transfer of length four is performed.
Select the service mode between single service mode and whole
service mode.
0 = Single service mode is selected in which after each atomic
S3C2416X RISC MICROPROCESSOR
Description
Description
Reset Value
0x00000000
0x00000000
0x00000000
0x00000000
0x00000000
0x00000000
Initial State
0
0
0
0
0