Dma Mask Trigger Register (Dmasktrig) - Samsung S3C2416 User Manual

DMA CONTROLLER

4.9 DMA MASK TRIGGER REGISTER (DMASKTRIG)

Register
DMASKTRIG0 0x4B000020
DMASKTRIG1 0x4B000120
DMASKTRIG2 0x4B000220
DMASKTRIG3 0x4B000320
DMASKTRIG4 0x4B000420
DMASKTRIG5 0x4B000520
DMASKTRIGn Bit
STOP [2]
ON_OFF [1]
SW_TRIG [0]
NOTE: You can freely change the values of DISRC register, DIDST registers, and TC field of DCON register. Those changes
take effect only after the finish of current transfer (i.e., when CURR_TC becomes 0). On the other hand, any change
made to other registers and/or fields takes immediate effect. Therefore, be careful in changing those registers and
fields.
8-16
Address R/W
R/W DMA0 Mask Trigger Register
R/W DMA1 Mask Trigger Register
R/W DMA2 Mask Trigger Register
R/W DMA3 Mask Trigger Register
R/W DMA4 Mask Trigger Register
R/W DMA5 Mask Trigger Register
Stop the DMA operation.
1 = DMA stops as soon as the current atomic transfer ends. If there
is no current running atomic transfer, DMA stops immediately. The
CURR_TC, CURR_SRC, CURR_DST will be 0.
Note: Due to possible current atomic transfer, "stop" may take several
cycles. The finish of "stopping" operation (i.e., actual stop time) can be
detected by waiting until the channel on/off bit (DMASKTRIGn[1]) is set to
off. This stop is "actual stop".
DMA channel on/off bit.
0 = DMA channel is turned off. (DMA request to this channel is
ignored.)
1 = DMA channel is turned on and the DMA request is handled.
This bit is automatically set to off if we set the DCONn[22] bit to "no
auto reload" and/or STOP bit of DMASKTRIGn to "stop".
Note that when DCON [22] bit is "no auto reload", this bit becomes
0 when CURR_TC reaches 0. If the STOP bit is 1, this bit becomes
0 as soon as the current atomic transfer finishes.
Note: This bit should not be changed manually during DMA operations
(i.e., this has to be changed only by using DCON [22] or STOP bit.)
Trigger the DMA channel in S/W request mode.
1 = it requests a DMA operation to this controller.
However, note that for this trigger to have effects S/W request
mode has to be selected (DCONn[23]) and channel ON_OFF bit
has to be set to 1 (channel on). When DMA operation starts, this bit
is cleared automatically.
S3C2416X RISC MICROPROCESSOR
Description
Description
Reset Value
000
000
000
000
000
000
Initial State
0
0
0