Loss Of Signal Alarm Inquiry Test - Avaya DEFINITY Server CSI Maintenance Manual

Maintenance Objects
Table 340. TEST #53 SAKI Sanity Test — Continued
Error Test
Code Result
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
This should re-establish the linkage between the internal ID and the port.

Loss of Signal Alarm Inquiry Test (#138)

This test is meaningless for the TN802 MAPD circuit pack.
test results.
Table 341. Loss of Signal Inquiry Test (#138) results
Windows NT
up on the
TN802?
Y
Y
N
1368
Issue 5 October 2002
Description/ Recommendation
1. Ensure that the board translations are correct. Execute the add ds1
UUCSS command to administer the MAPD interface if it is not already
administered.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the board
is shut down. Reseating the board re-initializes the board.
3. If the board was found to be correctly inserted in step 1, then issue the
busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
Then
Test passes
Test aborts with ABORT
2000 Error Code.
Test aborts with ABORT
2000 Error Code.
Continued on next page
Table 341
Cause
Windows NT is not communicating
with the angel firmware.
Windows NT down.
details the