Optional) Configuring 802.1X Re-Authentication - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Security
Step 3 Run:
dot1x quiet-times fail-times
The number of authentication failures within 60 seconds before the 802.1x user enters the silent
state is set.
By default, the number of authentication failures within 60 seconds before the 802.1x user enters
the silent state is 3.
----End

2.4.12 (Optional) Configuring 802.1x Re-authentication

Context
The S3700 re-authenticates users who pass 802.1x authentication after a period of time to ensure
the validity of users.
You can configure 802.1x re-authentication in the following ways.
Procedure
l
l
----End
Issue 01 (2011-07-15)
In the system view:
1. Run:
system-view
The system view is displayed.
2. Run:
dot1x reauthenticate interface { interface-type interface-number1 [ to
interface-number2 ] } &<1-10>
Re-authentication is enabled on interfaces.
You can configure 802.1x re-authentication on interfaces in batches by specifying the
interface list in the dot1x reauthenticate command in the system view.
In the interface view:
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
dot1x reauthenticate
Re-authentication is enabled on the interface.
By default, 802.1x re-authentication is disabled on an interface.
You can run the dot1x timer command to set the timeout interval of re-authentication. For
details, see 2.4.10 (Optional) Configuring 802.1x
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 NAC Configuration
Timers.
64