Ip Dhcp Snooping Binding; Ip Verify Binding; Ip Dhcp Snooping Limit - NETGEAR ProSafe GSM7224P User Manual

no ip dhcp snooping database write-delay
Use this command to set the write delay value to the default value.
Format
no ip dhcp snooping database write-delay
Mode
Global Config

ip dhcp snooping binding

Use this command to configure static DHCP Snooping binding.
Format
ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode
Global Config
no ip dhcp snooping binding <mac-address>
Use this command to remove the DHCP static entry from the DHCP Snooping database.
Format
no ip dhcp snooping binding <mac-address>
Mode
Global Config

ip verify binding

Use this command to configure static IP source guard (IPSG) entries.
Format
ip verify binding <mac-address> vlan <vlan id> <ip address> interface
<interface id>
Mode
Global Config
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format
no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <interface id>
Mode
Global Config

ip dhcp snooping limit

Use this command to control the rate at which the DHCP Snooping messages come. The
default rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a
range of 1 to 15 seconds.
Default
15 pps for rate limiting and 1 sec for burst interval
ProSafe Managed Switch
Switching Commands
147