Multiple Clients Per Atm Subinterface; Figure 4: Multiple Ppp Clients Per Atm Subinterface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers broadband access configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (750 pages)
Table of Contents
Advertisement
JunosE 11.3.x Broadband Access Configuration Guide
Multiple Clients per ATM Subinterface
60
Configure the subinterface.
2.
host1(config-if)#interface atm 0/1.20
Configure a permanent virtual circuit (PVC) by specifying the vcd (virtual circuit
3.
descriptor), the vci (virtual channel identifier), the vpi (virtual path identifier), and the
encapsulation type.
host1(config-if)#atm pvc 10 22 100 aal5snap
Configure PPP encapsulation.
4.
host1(config-if)#encapsulation ppp
Configure PAP or CHAP authentication.
5.
host1((config-if))#ppp authentication chap
Assign a profile to the PPP interface.
6.
host1(config-subif)#profile foo
Figure 4 on page 60 shows how PPPoE supports multiplexing of multiple PPP sessions
per ATM subinterface.
Figure 4: Multiple PPP Clients per ATM Subinterface
Configure an ATM interface by entering Configuration mode and performing the following
tasks. For more information about configuring ATM interfaces, see JunosE Link Layer
Configuration Guide.
Configure a physical interface.
1.
host1(config)#interface atm 0/1
Configure the subinterface.
2.
host1(config-if)#interface atm 0/1.20
Configure a PVC by specifying the vcd (virtual circuit descriptor), the vci (virtual channel
3.
identifier), the vpi (virtual path identifier), and the encapsulation type.
host1(config-if)#atm pvc 10 22 100 aal5snap
Configure PPPoE encapsulation.
4.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
