Figure 23: Subscriber Interfaces Using A Source Address To Demultiplex; Traffic - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
610

Figure 23: Subscriber Interfaces Using a Source Address to Demultiplex

Traffic

E Series router
To configure the static subscriber interfaces shown in Figure 23 on page 610, perform the
following steps:
Configure a primary IP interface on a supported layer 2 interface.
1.
a. Create a layer 2 interface.
host1(config)#interface fastEthernet 4/1
b. Create a primary IP interface.
host1(config-if)#ip address 10.1.1.1 255.255.255.0
c. Exit Interface Configuration mode.
host1(config-if)#exit
Configure subscriber interface IP1.
2.
a. Create the shared IP interface.
host1(config)#virtual-router vra
Proceed with new virtual-router creation? [confirm] yes
host1:vra(config)#interface ip ip1
Copyright © 2010, Juniper Networks, Inc.