Tunnel Accounting Messages - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BROADBAND ACCESS CONFIGURATION GUIDE 2010-10-12 Configuration Manual

JunosE 11.3.x Broadband Access Configuration Guide
Table 40: AAA Accounting Message Juniper Network (Vendor ID 4874) VSAs Supported (continued)
Attribute
Number Attribute Name
[26-124] Act-Interlv-Delay-Up
[26-125] Max-Interlv-Delay-Dn
[26-126] Act-Interlv-Delay-Dn
[26-127] DSL-Line-State
[26-128] DSL-Type
[26-129] Ipv6-NdRa-Prefix
[26-150] ICR-Partition-Id
(See Note 3.)
[26-151] Ipv6-Acct-Input-Octets
(See Note 2.)
[26-152] Ipv6-Acct-Output-Octets
(See Note 2.)
[26-153] Ipv6-Acct-Input-Packets
(See Note 2.)
[26-154] Ipv6-Acct-Output-Packets
(See Note 2.)
[26-155] Ipv6-Acct-Input-Gigawords
(See Note 2.)
[26-156] Ipv6-Acct-Output-Gigawords
(See Note 2.)
[26-159] DHCP-Option 82
(See Note 1.)

Tunnel Accounting Messages

Table 41 on page 185 lists RADIUS attributes supported by the following tunnel-related
accounting messages:
184
Acct-Start
–
–
–
–
–
–
Acct-Tunnel-Start
Acct-Tunnel-Stop
Acct-Tunnel-Reject
Acct-Tunnel-Link-Start
Acct-Stop Interim-Acct Acct-On
–
–
–
–
–
–
–
–
–
–
–
–
–
–
Copyright © 2010, Juniper Networks, Inc.
Partition- Partition-
Acct-Off A c c o u n t i n g - O n A c c ounti n g-Off
– – –
– – –
– – –
– – –
– – –
– – –
–
– – –
– – –
– – –
– – –
– – –
– – –
– – –